Hawkeye 鹰眼科技 Home Firmware Split Cam 查看内容

Hawkeye Firefly Split Cam Firmware update 20190926

2019-9-28 10:50| 发布者: 鹰眼| 查看: 261| 评论: 0

Update List:
1. Fixed the Manual speed problem, and add two new shutter speed.
2.  Fixed the ESI can't turn on while distortion correction is ON.
3. Add Hawkeye 4 White balance for 170 degress Large FOV lens.
4. Start recording : bi bi bi;  Stop recording : bi-bi bi bi bi. Make the beep voice more easy to  identify.
5. HDMI output set defalut to 720P 60FPS. Because some monitor can not recognize 30fps.

For More WDR Suggestion: WDR - ON

Download: 

How to update:

1.Delete all the files and folders in the tf card(suggest:8G/16G).
2.Download the firmware to sd card .
3.Put the sd card into camere(make sure battery > 50%).
4.Power on the camera and it will update firmware automatically.
5.When updating, the LED will flash it takes about one minutes, Don't power off when updating, or it will....die.
6.When update finish, the camera will turn on again.


更新列表:
1.解决手动曝光返回自动曝光时无效的问题。
2. 解决即便校正打开后,陀螺仪无法开启的问题。
3.增加 鹰眼4白平衡专门给 170度大角度镜头。
4.蜂鸣器声音更改:开始录像 : 哔哔哔; 停止录像: 哔-哔哔哔。 更容易识别。
5. HDMI 默认改为 720P 60FPS;  基于部分显示器不识别 30fps,考虑到用户容易使用。

如果需要更强的宽动态建议设置:宽动态 - 开


更新方法:
1.先将TF卡(8G/16G)清空所有文件/文件夹 .
2.下载固件到 SD 卡上 .
3.将SD卡放到机器里面.
4.重新开机(注意电池必须保证电量>50%).
5.更新过程中,LED灯会闪烁,更新过程需时1分钟,更新过程请勿关机,否者....会成砖.
6.更新完成后,机器会自动关机.
7.更新完成后,长按电源键重启即可 .

下载:
链接:https://pan.baidu.com/s/1D3YmOmJruwuxTFFXDwbuBg 
提取码:tsuq  
上一篇:Split Cam FPV CABLE
 
QQ在线咨询
咨询热线
+86-134-243-36270
返回顶部