Update List: 1. Add OSD voltage display(wide voltage input 6-23V) 2. Long press to power up by default, one press to power up when quick capture is ON. 3.Optimize video quality. Firmware How to update: 1.Delete all the files and folders in the tf card(suggest:8G-32G). 2.Download the firmware to sd card . 3.Put the sd card into camere(make sure battery > 50%). 4.Power on the camera and it will update firmware automatically. 5.When updating, the LED will flash it takes about one minutes, Don't power off when updating, or it will....die. 6.When update finish, the camera will turn on again. How to configer the FC ? PLEASE check the Newst Manual: 更新列表： 1.增加OSD 电压显示， 显示宽电压输入（6-23V)。 2.默认长按开机，当快速录像开启时，短按开机。 3.优化视频。 固件： 更新方法： 1.先将TF卡(8G-32G)清空所有文件/文件夹 . 2.下载固件到 SD 卡上 . 3.将SD卡放到机器里面. 4.重新开机（注意电池必须保证电量>50%). 5.更新过程中，LED灯会闪烁,更新过程需时1分钟，更新过程请勿关机，否者....会成砖. 6.更新完成后，机器会自动重启. |
